Could be a silly question.....

Enginewidow
Posts: 2
Joined: Sun Aug 31, 2014 7:07 pm

Could be a silly question.....

Postby Enginewidow » Sun Aug 31, 2014 7:33 pm

Hi all, ok the restoration has begun, I brought my second Wolseley 2 years ago and its been stood up doing nothing for all that time. I had a look at it yesterday and it has very poor compression and have been told that would most likely be the valves, luckily I have some new ones here. When I checked the state of the oil it was very creamy so I am hoping its just where its been sat up for so long rather than head gasket. Anyway my question is I drained of the oil (well, water mainly) yesterday but how can I make sure I have it all out? I don't want to find the engine is all sorted but have a load of sludge having around somewhere or would that not be possible?
Thanks in advance
Julie

User avatar
Richard
Site Admin
Posts: 246
Joined: Mon Aug 10, 2009 6:47 am

Re: Could be a silly question.....

Postby Richard » Tue Nov 11, 2014 9:15 am

Hi Julie. Not a silly question. I would run a number of oil changes through the engine to clean the gunk out. Much quicker than a full dismantle.
Regards
Richard Banks
AUSTRALIA


Return to “WD2 (WDII)”

Who is online

Users browsing this forum: No registered users and 1 guest